codes.crepp.org

#include <AltSoftSerial.h>

// AltSoftSerial show configuration example
// Will print library configuration to default serial port
// Open your serial monitor to see config for your board
// Printout would repeat every 10sec (just in case you missed it somehow)

// Print Configuration
// -----------------------

// Direct include AltSoftSerial internals to obtaion PIN setup (you do not need this in regular code)

// This example code is in the public domain.

#include <config/AltSoftSerial_Boards.h>

void printAltSoftSerialSetup(Stream &port)
{
#define PRINT_PFX "AltSoftSerial:"
#define PRINT_PIN_NAME(pin,name) { char buffer[128+1]; sprintf(buffer, PRINT_PFX "PIN:%2d %s", (int)pin, (const char*)name); port.println(buffer); }

	port.println(PRINT_PFX "Setup info: begin");

#if defined(ALTSS_USE_FTM0)
	port.println(PRINT_PFX "USE FTM0");
#endif

#if defined(ALTSS_USE_TIMER1)
	port.println(PRINT_PFX "USE TIMER1");
#endif

#if defined(ALTSS_USE_TIMER2)
	port.println(PRINT_PFX "USE TIMER2");
#endif

#if defined(ALTSS_USE_TIMER3)
	port.println(PRINT_PFX "USE TIMER3");
#endif

#if defined(ALTSS_USE_TIMER4)
	port.println(PRINT_PFX "USE TIMER4");
#endif

#if defined(ALTSS_USE_TIMER5)
	port.println(PRINT_PFX "USE TIMER5");
#endif

#if defined(INPUT_CAPTURE_PIN)
	PRINT_PIN_NAME(INPUT_CAPTURE_PIN,"RX");
#endif

#if defined(OUTPUT_COMPARE_A_PIN)
	PRINT_PIN_NAME(OUTPUT_COMPARE_A_PIN,"TX");
#endif

#if defined(OUTPUT_COMPARE_B_PIN)
	PRINT_PIN_NAME(OUTPUT_COMPARE_B_PIN,"(unused PWM)");
#endif

#if defined(OUTPUT_COMPARE_C_PIN)
	PRINT_PIN_NAME(OUTPUT_COMPARE_C_PIN,"(unused PWM)");
#endif

#if defined(OUTPUT_COMPARE_D_PIN)
	PRINT_PIN_NAME(OUTPUT_COMPARE_D_PIN,"(unused PWM)");
#endif

#if defined(OUTPUT_COMPARE_E_PIN)
	PRINT_PIN_NAME(OUTPUT_COMPARE_E_PIN,"(unused PWM)");
#endif

#if defined(OUTPUT_COMPARE_F_PIN)
	PRINT_PIN_NAME(OUTPUT_COMPARE_F_PIN,"(unused PWM)");
#endif

	port.println(PRINT_PFX "Setup info: end");

#undef  PRINT_PIN_NAME
#undef  PRINT_PFX
}

void setup()
{
	// Open default serial to dump config to
	Serial.begin(9600);
	while (!Serial) ; // wait for serial monitor
	printAltSoftSerialSetup(Serial);
}

void loop()
{
	// Repeat every 10 sec (just in case)
	delay(10000);
	Serial.println("");
	printAltSoftSerialSetup(Serial);
}