/*
* The MySensors Arduino library handles the wireless radio link and protocol
* between your home built sensors/actuators and HA controller of choice.
* The sensors forms a self healing radio network with optional repeaters. Each
* repeater and gateway builds a routing tables in EEPROM which keeps track of the
* network topology allowing messages to be routed to nodes.
*
* Created by Henrik Ekblad <henrik.ekblad@mysensors.org>
* Copyright (C) 2013-2019 Sensnology AB
* Full contributor list: https://github.com/mysensors/MySensors/graphs/contributors
*
* Documentation: http://www.mysensors.org
* Support Forum: http://forum.mysensors.org
*
* This program is free software; you can redistribute it and/or
* modify it under the terms of the GNU General Public License
* version 2 as published by the Free Software Foundation.
*
*******************************
*
* DESCRIPTION
*
* Example for sending debug messages over the air (OTA).
*
*/
// Enable debug
#define MY_DEBUG
// Enable OTA debugging to Node 0
#define MY_DEBUG_OTA (0)
// Allow sending logs without MY_DEBUG_OTA enabled
#define MY_OTA_LOG_SENDER_FEATURE
// Disable echoing of debug messages
//#define MY_DEBUG_OTA_DISABLE_ECHO
// Enable and select radio type attached
#define MY_RADIO_RF24
//#define MY_RADIO_NRF5_ESB
//#define MY_RADIO_RFM69
//#define MY_RADIO_RFM95
#include <MySensors.h>
void setup()
{
}
void presentation()
{
// Send the sketch version information to the gateway and Controller
sendSketchInfo("DebugSensor", "1.0");
}
// Arduino loop
int c=0;
void loop()
{
// Wait some time
if (sleep(3000)==MY_SLEEP_NOT_POSSIBLE) {
delay(3000);
}
// Count loops
c++;
// A debug message
DEBUG_OUTPUT(PSTR("DEBUG\nc=%" PRId16 "\nmillis=%" PRId32 "\n"), c, hwMillis());
// Send a log message to a node, requesting that the message is echoed back to this node
OTALog(0, true, PSTR("LOG\nc=%" PRId16 "\nmillis=%" PRId32 "\n"), c, hwMillis());
}